I have a type-J thermocouple hooked up to the controller. I am trying to adjust the PV offset, but it will not go higher than +87 F. I seem to have reached the 10%FS limit and I need 20 F more in order to have the proper PV reading.
Anybody knows how to change this FS value so I can increase my limit or is this an indication of something not right with the thermocouple ? (It is a brand new thermocouple)
hi, i'm interested to use this furnace to complete my experiment. i want to ramp up to 950 degrees in 2 hours and soak for 8 hours and after that ramp down also for 2 hours.
so how to set to that temperature? could u please help me?
Another question from a customer that, I thought, could be useful for some people: " Do you market a temperature controller with a proportional output at mains voltages capable of handling 5 amps? We require the current to be continuous, varying only to adjust the temperature. It is for an air heater with a low thermal mass so we require continuous proportional control, a simple on/off type (relay output) would be clicking away all the time with consequent fluctuations in air temperature. "
May I have the comparison between these two brand:HAKKO HMI and PROFACE HMI.Which one is more user friendly and more accceptable with most programming language?