2015-12-05 16:42:34

0

0

How pyro meter work?
how its actually detects temperature.
how many types of pyrometer exist?

2015-02-12 21:08:56

0

0

I have a type-J thermocouple hooked up to the controller. I am trying to adjust the PV offset, but it will not go higher than +87 F. I seem to have reached the 10%FS limit and I need 20 F more in order to have the proper PV reading.

Anybody knows how to change this FS value so I can increase my limit or is this an indication of something not right with the thermocouple ? (It is a brand new thermocouple)

2013-07-18 05:11:03

0

0

could you please explain what is the meaning/function of parameters of the first block, second block and third block?

2013-07-17 06:21:25

0

0

How to appear display(digital no) at PV?

2013-07-17 05:02:39

0

0

hi,
i'm interested to use this furnace to complete my experiment. i want to ramp up to 950 degrees in 2 hours and soak for 8 hours and after that ramp down also for 2 hours.

so how to set to that temperature? could u please help me?

2009-03-27 19:32:31

0

0

Another question from a customer that, I thought, could be useful for some people:
"
Do you market a temperature controller with a proportional output at mains voltages capable of handling 5 amps?
We require the current to be continuous, varying only to adjust the temperature. It is for an air heater with a low thermal mass so we require continuous proportional control, a simple on/off type (relay
output) would be clicking away all the time with consequent fluctuations in air temperature.
"

(our answer in the reply)

2009-03-27 04:43:14

0

0

plz giv the detail of the keypad(microcontroller pxz) supplier in india.

2008-11-08 23:53:39

0

0

May I have the comparison between these two brand:HAKKO HMI and PROFACE HMI.Which one is more user friendly and more accceptable with most programming language?

Tks Fred

2008-09-24 13:01:08

0

0

This question has been asked by one of our customer and I thought it my be useful to other people:

While in the main screen, press and maintain the SEL button for around 3 seconds.

A parameter should appear "Prog" or "roff" on the SV screen.

Release the SEL button. Then press it again normally - that will switch between the different parameters.

After pressing few times, you should reach "AT" (auto tune settings) which look like more "A7 0" on the screen.

"0" being the parameter at which it is set at:
0: off
1: Standard
2: low PV

You want to change it to "1" with the arrow key.
You will then have "A7 1" displayed.

Then, press and maintain the select button until coming back to the main screen.

That's it!